Blog

50mm floor part – render
15th Feb, 2015

These are the new 50mm floor part for the sloped wall tile set. The playing surface is made up of 4 x 25mm grills, to allow two 25mm based miniatures to stand side by side. The locking tabs are like those plastic side release buckles. Once connected the floor parts should be pretty stable during gaming.

The concern is the prongs on the locking mechanism. I’m going to print these up via Shapeways to see if they are flexible and strong enough. I know Trollcast is very different from the Acrylic of Frosted Ultra Detail but it should give me and idea.

Leave a Reply

Your email address will not be published. Required fields are marked *

Copyright © 2004-2018 Philip Sibbering. All Rights Reserved.